beautypg.com

Craftsman 917.272850 User Manual

Page 29

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TROUBLESHOOTING CHART:

See appropriate section in manual unless directed to Sears service center

PROBLEM

CAUSE

CORRECTfON

Loss of power

1. Cutting too much grass/too

1. Set in “Higher Cut” position/

fast.

reduce speed.

2. Throttle in “CHOKE”

position.

2. Adjust throttle control.

3. Build-up of grass, leaves

3. Clean underside of mower

and trash under mower.

housing.

4. Dirty air filter.

4. Clean/replace air filter.

5. Low oil level/dirty oil.

5. Check oil level/change oil.

6. Faulty spark plug.

6. Clean and regap or change

spark plug.

7. Dirty fuel filter.

7. Replace fuel filter.

8. Stale or dirty fuel.

8. Drain fuel tank and refill with

fresh gasoline.

9. Water in fuel.

9. Drain fuel tank and carbure­

tor, refill tank with fresh
gasoline and replace fuel
filter.

10. Spark plug wire loose.

10. Connect and tighten spark

plug wire.

11. Dirty engine air screen/fins.

11 .Clean engine air screen/fins.

12.Dlrty/clogged muffler.

12. Clean/replace muffler.

13. Loose or damaged wiring.

13. Check all wiring.

14. Carburetor out of

14.See “To Adjust Carburetor”

adjustment.

in Service and Adjustments

section.

15. Engine valves out of

15. Contact a Sears or other

adjustment.

qualified service center.

Excessive

1. Worn, bent or loose blade.

1. Replace blade.

vibration

Tighten blade bolt.

2. Bent blade mandrel.

2. Replace blade mandrel.

3. Loose/damaged part(s).

3. Tighten loose part(s).

Replace damaged parts.

Engine continues

1. Faulty operator-safety

1. Check wiring, switches and

to run

presence control system.

connections. If not

when operator

contact a Sears or other

leaves seat with

with attachment

ciutch engaged

qualified service center.

Poor cut - uneven

1. Worn, bent or loose blade.

1. Replace blade. Tighten

blade bolt.

2. Mower deck not level.

2. Level mower deck.

3. Buildup of grass, leaves,

3. Clean underside of mower

and trash under mower.

housing.

4. Bent blade mandrel.

4. Replace blade mandrel.

5. Clogged mower deck vent

5. Clean around mandrels to

holes from buildup of
grass, leaves, and trash
around mandrels.

open vent holes.

29