Craftsman 973.113900 - Manual (Page 5)

OPERATION
TO INSTALL/REMOVE BATTERY PACK
See Figure 2.
■ Use only the recommended battery pack with your
worklight.
^ WARNING: Do not install battery pack to your
worklight until you have read and understood all
precautions and operating instructions in the
manual and printed on battery pack and charger.
■ Orient battery pack so that raised rib on battery
pack aligns with groove inside worklight. Battery
pack is designed to fit only one way in worklight
handle.
■ Insert battery pack, making sure latches on each
side of battery pack snap into place and battery
pack is secure in worklight before use.
^ CAUTION: When placing battery pack in your
worklight, be sure raised rib on battery pack
aligns with groove inside worklight handle and
latches snap into place properly. Improper
assembly of battery pack can cause damage to
internal components.
■ To remove battery pack, locate latches on end of
battery pack and depress to release battery pack
from your worklight.
SWITCH
See Figure 3.
To turn your worklight on and off, depress switch
trigger.
MULTI-POSITION HEAD
See Figure 3.
Your worklight has the feature of a multi-position
head. Rotate head to the desired position as shown in
the arrows in Figure 3.
MULTI-POSITION
HEAD
SWITCH
TRIGGER
Fig.3