Step 15: install dump handle tube extension, See figure 14), Step 16: install dump control pin – Craftsman 486.248473 User Manual

Page 11: See figure 15)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

STEP 14: INSTALL DUMP HANDLE TUBE
(SEE FIGURE 13)

• Install the dump handle tube to the dump pivot bracket

assembly using three 5/16" x 1 -3/4" hex bolts (G) and
5/16" nylock nuts (S).

STEP 15: INSTALL DUMP HANDLE TUBE EXTENSION
(SEE FIGURE 14)
•

Install the dump handle tube extension on the dump

handle tube using a 1/4" x 1 -3/4" hex bolt (H) and 1/4"
nylock nut (T).

* Attach the dump cable to the dump handle tube using

three cable ties (OO).

STEP 16: INSTALL DUMP CONTROL PIN
(SEE FIGURE 15)
•

Install a small 1/2" washer (FF) and then the

compression spring (MM) onto the dump control pin.

Install the dump control pin into the pin stop bracket.
Make sure the flat side of the pin faces to the front

when finished.

•

Connect the hooked end of the dump cable into the
hole in the dump control pin. install the threaded cable
adjuster down into the notch in the pin stop bracket,
placing a nut on each side of the notch. Adjust and
tighten the adjuster nuts so that the tapered end of
the dump control pin extends 3/4" through the side of
the pin stop bracket.