Capresso H2O PRO 275 User Manual
Page 9
Please note: if the selected heating temperature is set to 212ºF or
200ºF degrees the warm-keeping temperature cannot be set higher
than 190ºF.
After the selected heating temperature is reached, the display will now
change to the preselected warm-keeping temperature. The warm-keeping
symbol and the warm-keeping temperature are displayed. Once the
water cools to approx. 10ºF below the pre-set warm-keeping temperature,
the heater will automatically start re-warming the water to the pre-set
temperature. During this time the warm-keeping symbol will be blinking.
The kettle will keep the selected temperature for up to 40 minutes.
After 40 minutes the warm-keeping symbol stops blinking indicating
that the heating element has shut off.
Please note: once you remove the kettle from the power base, all
pre-sets are cancelled.
Tip: If you want to pour water immediately after brewing and then keep
the rest at a certain temperature, proceed as follows:
• Follow the instructions under chapter 1 or 4.
• Pour the desired amount of water.
• Replace the kettle.
• Select the brewing temperature by pushing the arrow buttons.
• Push the program button once to show the warm-keeping display
000ºF. Use the arrow buttons to select the desired warm-keeping
temperature.
• Push the On/Off button.
The kettle is now on. Depending on the temperature of the water it will
either re-heat the water immediately or later.
6. CHLORINE REDUCING SETTING / EXTENDED BOIL SETTING
If you boil the water in the default setting, the kettle will shut off 3 seconds
after the sensor registered the boiling temperature. You can prolong the
actual boiling action as follows:
• Set the Chlorine symbol to “CL”, this will add three extra seconds to
the boiling of the water.
• Change the Timer Setting from 003 (seconds) to any duration up to
20 seconds (020).
• Prepare the kettle as explained in chapter 1.
• Before you push the On/Off button, push the program button twice,
the Chlorine symbol appears (Fig. 3c).
• Push either arrow button once, the display shows “CL”.
• Push the program button again. The display shows the timer symbol
and 003 (Fig. 3d).
9.