Craftsman 917.271742 - Manual (Page 32)

TROUBLESHOOTING CHART
PROBLEM CAUSE CORRECTION
Poor grass
discharge 1. Engine speed too slow.
2. Travel speed too fast.
3. Wet grass.
4. Mower deck not level.
5. Low/uneven tire air pressure.
6. Worn, bent or loose blade.
7. Buildup of grass, leaves and
trash under mower.
8. Mower drive belt worn.
9. Blades improperly installed.
10. Improper blades used.
11. Clogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels.
Headlight(s) not
working
(if so equipped)
1. Switch is “OFF".
2. Bulb(s) burned out.
3. Faulty tight switch.
4. Loose or damaged wiring,
5. Blown fuse.
1. Turn switch “ON”.
2. Replace bulb(s).
3. Check/replace light switch.
4. Check wiring and connec­
tions.
5. Replace fuse.
Battery will not
charge 1. Bad battery cell(s).
2. Poor cable connections.
3. Faulty regulator
(If so equipped).
4. Faulty alternator.
1. Replace battery.
2. Check/clean all connec­
tions.
3. Replace regulator.
4. Replace alternator.
Loss of drive 1. Freewheel control in
“disengaged" position.
2. Motion drive belt worn,
damaged, or broken.
3. Air trapped in transmission
during shipment or
servicing.
1. Place freewheel control in
“engaged" position.
2. Replace motion drive belt.
3. Purge transmission.
Engine “backfires”
when turning
engine
"OFF”
1. Engine throttle control not
set at “SLOW”
position for 30 seconds
before stopping engine.
1. Move throttle control to
“SLOW" position and allow
to idle for 30 seconds before
stopping engine.
Place throttle control in
“FASF position.
Shift to slower speed.
Allow grass to dry before
mowing.
Level mower deck.
Check tires for proper air
pressure.
Replace/sharpen blade.
Tighten blade bolt.
Clean underside of mower
housing.
Replace mower drive belt.
Reinstall blades sharp edge
down.
10. Replace with blades listed
in this manual.
11. Clean around mandrels to
open vent holes.
32