Craftsman 917.276030 - Manual (Page 15)

The cutting height range is approximately
1-1/2" to 4*1/2". The heights are mea­
sured from the ground to the blade tip with
the engine not running. These heights
are approximate and may vary depending
upon soil conditions, height of grass and
types of grass being mowed.
• The average lawn should be cut to
approximately 2-1/2 inches during the
cool season and to over 3 inches during
hot months. For healthier and better
looking lawns, mow often and after
moderate growth.
* For best cutting performance, grass over
6 inches in height should be mowed
twice. Make the first cut relatively high;
the second to desired height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted
when they are slightly off the ground when
mower is at the desired cutting height in
operating position. Gauge wheels then
keep the deck in proper position to help
prevent scalping in most terrain conditions.
NOTE: Be sure tractor is on a flat level
surface.
1. Lower mower and adjust mower to de­
sired cutting height(See ‘TO ADJUST
MOWER CUTTING HEIGHT" in this
section of manual).
2. Remove retainer spring and clevis pin
which secure each gauge wheel bar,
3. Lower gauge wheels to ground. Raise
gauge wheels slightly to align holes
in bracket and gauge wheel bar and
insert clevis pin. Gauge wheels should
be slightly off the ground.
4. Replace retainer spring into clevis pin.
5. Be sure all gauge wheels are in the
same setting.
IMPORTANT: Be sure to readjust gauge
wheels if you change the cutting height
of the mower deck.
Retainer
Spring
2 .
3.
Your tractor is equipped with an operator
presence sensing switch. Any attempt
by the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine.
1. Select desired height of cut.
Lower mower with attachment lift con­
trol.
Start mower blades by engaging at­
tachment clutch control.
TO STOP MOWER BLADES -
{^sengage attachment clutch control.
^CAUTION: Do not operate the mower
without either the entire grass catcher,
on mowers so equipped, or the deflector
shield in place.
, , Attachment Lift Lever
Attachment Clutch position
Switch Pull Out to..__/ Low
E n g a g e " I ..^Position
Deflector
Shield
TO OPERATE MOWER
Push In To
"Disengage"
TO OPERATE ON HILLS
^WARNING: Do not drive up or down
hills with slopes greater than 15“ and do
not drive across any slope. Use the slope
guide at the back of this manual.
• Choose the slowest speed before starting
up or down hills.
• Avoid stopping or changing speed on
hills.
• If slowing is necessary, move throttle
control lever to slower position.
• If stopping is absolutely necessary, push
clutch/brake pedal quickly to brake position
and engage parking brake.
• Move gearshift leverto 1 st gear and range
shift lever to low (L) position. Be sure you
have allowed room fortractor to roll slightly
as you restart movement.
• To restart movement, slowly release park­
ing brake and clutch/brake pedal.
• Make all turns slowly.
Clevis
Pin
15