Craftsman 636.796670 - Manual (Page 3)

Know ¥OyR BUSHWACKER
Your new BUSHWACKER has been carefuhy packed at the factory to prevent damage during shipping and storage,
however, even with the best of preventative measures, damage does sometimes occur It is recommended that you follow the
check out procedures listed below: _
Remove all items from the carton, lay them out and check the parts to be sure that you have everything required for
assembly. Also check carefully for any visible damage.. (IN THE EVENT THAT SOMETHING IS DAMAGED OR MISSING
OR BOTH, NOTIFY YOUR SEARS STORE IMMEDIATELY )
You should familiarize yourself with the various parts of your BUSHWACKER before attempting to assemble or operate
the unit Refer to drawing below.
SPECIFICATIONS
TYPE 2 cycle air-cooled
DISPLACEMENT 20.3 cc {1.24 Cu. In.)
Ш CARBURETOR Diaphragm type
s
5
z
FUELTANK
CAPACITY 17.5 U.S. ft. oz, {0.5E1
LU SPARKPLUG ■ NGK BM7A or CHAMPION CJ 6«
LUBRICATION Fuel oil Mixed 16 to 1
{1 gal. gasoline to 8 oz. oil)
DRYWEIGHT 10.5 lbs (4.8 kg)
DIMENSION 35.5 X 8.7 X 8.6 in.
OVERALL LENGTH 18"
Ш TOOTH PITCH 0.98"
LJ
< ENGINE RPM 8000 rpm
Ш CUTTING STROKES
PER MINUTE
32 2 times/sec (8000 rpm)
DRIVE SYSTEM
CLUTCH TYPE Dry Centrifugal
CLUTCH ENGAGE.
MENT
3800 rpm ±200 rpm
BLADE DRIVE Double cam drive
‘SEARS CATALOG NUMBER-36402
STARTER KNOB
FRONT HANDLE
START/STOP SWITCH
THROTTLE
LEVER
GUIDE PLATE
UPPER BLADE
REAR HANDLE
FUEL TANK
SHIELD
LOWER BLADE
Specifications are subject to change without notice.