beautypg.com

Muffler, Spark plug – Craftsman 917.389060 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TO CHANGE ENGINE OIL

NOTE:

Before tipping lawn mower to drain

oil, empty fuel tank by running engine until
fuel tank is empty.

1. Disconnect spark plug wire from spark

plug and place wire where it cannot
come in contact with plug.

2. Remove engine oil cap; lay aside on a

clean surface.

3. Tip lawn mower on its side as shown

and drain oil into a suitable container.

Rock lawn mower back and forth to re­
move any oil trapped inside of engine.

4. Wipe off any spilled oil from lawn

mower or side of engine.

5. Slowly pour oil down the oil fill spout,

stopping every few ounces to check the
oil level with the dipstick.

6. Stop adding oil when you reach the

FULL mark on the dipstick. Wait a
minute to allow oil to settle.

7. Continue adding small amounts of oil,

rechecking the dipstick until oil level
settles at FULL. DO NOT overfill, or
engine will smoke heavily from the muf­

fler on startup.

8. Always be sure to retighten oil dipstick

before starting engine.

9. Reconnect spark plug wire to plug.

Install cartridge, then replace cover

making sure the tabs are aligned with

the slots in the back plate. Fasten
screw securely.

Back plate

AIR FILTER

^

Your engine will not run properly and may '

be damaged by using a dirty air filter.
Replace the air filter cartridge every

100

,

hours of operation or every season, which- '
ever occurs first. Service air cleaner more
often under dusty conditions.

,

TO CLEAN AIR FILTER

1. Loosen screw and tilt cover to remove. •

2. Carefully remove cartridge.
3. Clean by gently tapping on a flat sur­

face. If very dirty, replace cartridge.

ACAUTION: Petroleum solvents, such as

kerosene, are not to be used to clean car­

tridge. They may cause deterioration of the
cartridge. Do not oil cartridge. Do not use

pressurized air to clean or dry cartridge, -j 3

MUFFLER

Inspect and replace corroded muffler as it

could create a fire hazard and/or damage.

SPARK PLUG

Replace spark plug at the beginning of

each mowing season or after every 100
hours of operation, whichever occurs
first. Spark plug type and gap setting
are shown in the “PRODUCT SPECIFIC­

ATIONS” section of this manual.

CLEANING

IMPORTANT:

For best performance,

keep mower housing free of built-grass
and trash. Clean the underside of your
mower after each use.

ACAUTION:

Disconnect spark plug wire

from spark plug and place wire where it
cannot come in contact with plug.

• Clean the underside of your lawn

mower by scraping to remove build-up
of grass and trash.

• Clean engine often to keep trash from

accumulating. A clogged engine runs
hotter and shortens engine life.

• Keep finished surfaces and wheels free

of all gasoline, oil, etc.

• We do not recommend using a garden

hose to clean lawn mower unless the
electrical system, muffler, air filter and
carburetor are covered to keep water
out. Water in engine can result in short­
ened engine life.