Craftsman 917.272247 - Manual (Page 21)

store in a safe place.
ALTERNATE SIDE-TO-SIDE
ADJUSTMENT METHOD
• Raise mower to its highest position.
• Measure height from bottom edge of
mower to ground level at front corners
of mower. Distance “A” on both sides
of mower should be the same.
• If adjustment is necessary, make
adjustment on one side of mower only.
• To raise one side of mower, tighten lift
link adjustment nut on that side.
• To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE: Each full turn of adjustment nut
will change mower height about 3/16".
• Recheck measurements after adjust­
ing.
FRONT-TO-BACK ADJUSTMENT
IMPORTANT; Deck must be level side-to-
side. If the following front-to-back
adjustment is necessary, be sure to adjust
both front links equally so mower will stay
level side-to-side.
To obtain the best cutting results, the
mower blades should be adjusted so the
front tip is approximately 1/8" to 1/2" lower
than the rear tip when the mower is in its
highest position.
A CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap
blade with heavy cloth.
Bottom Edge of
Mower to Ground Bottom Edge of
Mower to Ground
Lift Link
Adjustment
Nut
Check adjustment on right side of tractor.
Position any blade so the tip is pointing
straight forward. Measure distance "B" at
front and rear tip of blade
• Before making any necessary adjust­
ments, check that both front links are
equal in length.
• If links are not equai in length, adjust
one link to same length as other link.
• To lower front of blade, loosen nut “C”
on both front links an equal number of
turns.
NOTE: Each full turn of nut “C” will
change dim. “B” by approximately 3/16".
• When distance “B” is 1/8" to 1/2" lower
at front than rear, tighten nut “D” against
trunnion on both front iinks.
• To raise front of mower, loosen nut “F’
from trunnion on both front links.
Tighten nut "E” on both front links an
equal number of turns. The two front
links must remain equal in length.
• When distance “D” is 1/8" to 1/2" lower
at front than rear, tighten nut “P against
trunnion on both front links.
• Recheck side-to-side adjustment.
BOTH FRONT LINKS MUST BE EQUAL
IN LENGTH
Nut “D”
Front Piafé
Assembly
Nut “C”
Trunnion
21