Craftsman 917.255520 - Manual (Page 23)

SERVICE AND ADJUSTMENTS
TO REPLACE FUSE (See Fig. 29)
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located in the engine compartment, directly
in front of the dash.
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting.
• Check wiring. See eiectrical wiring diagram in Repair
Parts section of this manual,
TO REMOVE HOOD, GRILL AND SIDE PAN­
ELS (See Fig's. 30 and 31) •
• Raise hood.
• Unsnap headlight wire connector,
• Stand at side of tractor. Grasp hood and tilt forward
and lift off hinge brackets.
- To re install,slide hood pivot rod Into slot in hinge
brackets, and carefully reinstall hood springs.
23