beautypg.com

How to use your tractor – Craftsman 917.270770 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

FOfiE^GKT IS BETTER

THAN NO SIGHT

The operation of any tractor can result in foreign objects thrown into the
eyes, which can result in severe eye damage. Always wear safety glass­

es or eye shields while operating your tractor or performing any adjust­
ments or repairs. We recommend a wide vision safety mask over specta­
cles, or standard safety glasses.

HOW TO USE YOUR TRACTOR

Your tractor is equipped with an operator
presence sensing switch. When engine
is running, any attempt by the operator to
leave the seat without first setting the
parking brake will shut off the engine.
TO SET PARKING BRAKE
• Depress clutch/brake pedal into full

“BRAKE” position and hold.

• Place parking brake lever in

“ENGAGED” position and release pres­
sure from clutch/brake pedal. Pedal

should remain in “BRAKE” position.

Make sure parking brake will hold trac­

tor secure.

Choke Control Attachment Clutch Lever

“Engaged" Position

Throttle
Control

Clutch/Brake

Pedal “Drive'
Position

“Disengaged“
Position

Parking Brake
“Engaged“
Position

“Disengage
Position

■“Brake“ Gearshift

Adjustment position Lever

Knob

STOPPING

MOWER BLADES -
• To stop mower blades, move attach­

ment clutch lever to “DISENGAGED”
position.

-

GROUND DRIVE -
• To stop ground drive, depress

clutch/brake pedal into full “BRAKE"

position.

• Move gearshift lever to neutral (N) posi­

tion.

ENGINE -

• Move throttle control to slow position.

NOTE; Failure to move throttle control to

slow position and allowing engine to idle

before stopping may cause engine to
“backfire”.
• Turn ignition key to “OFP position and

remove key. Always remove key when
leaving tractor to prevent unauthorized
use.

• Never use choke to stop engine.

IMPORTANT: Leaving the ignition switch
in any position other than “OFP will cause
the battery to be discharged, (dead).

NOTE: Under certain conditions when

tractor is standing idle with the engine run­

ning, hot engine exhaust gases may

cause “browning” of grass. To eliminate
this possibility, always stop engine when

stopping tractor on grass areas.

^ CAUTION: Always stop tractor com­

pletely, as described above, before leaving
the operator's position; to empty grass
catcher, etc.
THROTTLE CONTROL
Always operate engine at full throttle.
• Operating engine at less than full throt­

tle reduces the battery charging rate.

• Full throttle offers the best bagging and

mower performance.

CHOKE CONTROL

Use choke control whenever you are start­
ing a cold engine. Do not use to start a

warm engine.
• To engage choke control, pull knob out.

Slowly push knob in to disengage.

TO MOVE FORWARD AND BACKWARD

The direction and speed of movement is
controlled by the gearshift lever.
• Start tractor with clutch/brake pedal

depressed and gearshift lever in neutral

(N) position.

• Move gearshift lever to desired posi­

tion.

• Slowly release clutch/brake pedal to

start movement.

IMPORTANT: Bring tractor to a complete
stop before shifting or changing gears.

Failure to do so will shorten the useful life

of your transaxle.

13