Craftsman C944.511590 - Manual (Page 7)

KNOW YOUR BRUSHCUTTER ATTACHMENT
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
BRUSHCUTTER ATTACHMENT. Compare the illustrations with your unit to familiar­
ize yourself with the location of various controls and adjustments. Save this
manual for future reference.
BLADE
The BLADE is designed for cutting grass,
weeds, and brush up to 1/2 inch in
diameter.
LOCKING LEVER
The LOCKING LEVER is used to prevent
the blade shaft from turning during
blade replacement.
OPERATING THE COUPLER
Your powerhead is equipped with a
coupler which enables optional attach­
ments to be installed- The optional at­
tachments are:
Edger..............................C944.511570
Cultivator........................ C944.511580
Blower............................ C944.511600
WARNING: Always disconnect
powerhead spark plug before remov­
ing or installing attachments.
REMOVING ATTACHMENT
CAUTION: When removing or instal­
ling attachments, place the powerhead
and attachment on a flat surface for
stability.
1. Loosen the coupler by turning the
knob counterclockwise.
Upper Tube
Coupler
\ ^ !LOOSEN
Lower \ j
Attachment
Knob
Press and hold the locking/release
button.
Locking/Release
Button
2 .
/ Coupler!
Lower Attachment
3.
Upper Tube
While securely holding the upper
tube, puli the attachment straight
out of the coupler.
INSTALLING ATTACHMENT
1. Remove the tube cap from the at­
tachment (if present) and discard.
2. Position locking/release button of
attachment into guide recess of
upper tube coupler.
Coupler Primary Hole
■ Guide Recess
TIGHTEN
Upper Locking/ Attachment
Tube Release
Button
3. Push the attachment into the cou­
pler until the locking/release button
snaps into the primary hole.