CLIFFORD cx-427 - Manual (Page 9)

5 © 2004 directed electronics, inc.
disarming
To disarm the system, unlock the doors using your factory keyless trans-
mitter. The horn will sound twice, and the parking lights (optional) will
flash twice. If the horn sounds either four or five times when disarm-
ing, refer to the Diagnostics section of this guide. This is called Tamper
Alert.
disarming without a transmitter
This feature allows you to override the system without the transmitter
should it be lost, damaged or disabled. To do this, you must have the ve-
hicle's ignition key and know where the integrated LED/Valet ® switch is
located. The Valet ® switch is activated by pressing the LED status indicator.
Turn the ignition to the “run”position.
Press and release the integrated
LED/Valet ® switch, within 10 seconds.
After a few seconds the LED will stop
flashing and the vehicle should start. If it does not, you may have waited
too long. Turn the ignition off and try again.
nnoottee:: The setting for the number of times the integrated
LED/Valet® switch must be pressed is set in the
Programming Section of this guide.
DRW-35
LED status indicator Integrated
LED/Valet switch