Craftsman 919.150020 - Manual (Page 4)

AWARNING
HAZARDS CAN OCCUR DURING NORMAL USE OF THIS EQUIPMENT.
PLEASE READ THE FOLLOWING CHART.
WHAT TO
LOOK FOR
WHAT COULD HAPPEN HOW TO PREVENT IT
Flammable
Spray
Materials
When paints or materials are sprayed, they are
broken into very small particles and mixed with air.
This will cause certain paints and materials to be­
come extremely flammable.
Never spray near open flames or pilot lights in stoves
or heaters.
Never smoke while spraying.
Provide ample ventilation when spraying indoors.
Toxic Vapors Some paints and coatings may be harmful if inhaled
or allowed to come into contact with skin or eyes.
Sprayed materials such as paint, paint solvents,
paint remover, etc., contain harmful vapors and
poisons.
Work in an area with good cross ventilation. Read
and follow the safety instructions provided on the
label or safety instructions. Provided on the
material label or safety data sheets for the material
you are spraying. Use a NIOSH/MSHA approved
respirator designed for use with your specific
application.
Compressed
Air Compressed air may propel dirt, metal shavings, etc.
and possibly cause an injury. Never point any nozzle or sprayer toward a person or
part of the body.
Always wear ansi 287.1 approved safety glasses
with side shields when using compressed air.
Certain parts are under pressure whenever the gun is
connected to a pressurized air line. These parts may
be propelled if the gun is disassembled.
Pressurized
Parts Disconnect the gun from the air line, or completely
depressurize the air line whenever the gun is to be
disassembled.
Explosion
Hazard -
Incompatible
Materials
The solvents 1,1,1-Trichloroethane and Methylene
Chloride can chemically react with the aluminum
used in most spray equipment, including this gun and
cup, to produce an explosion hazard.
Read the label or data sheet for the material you intend
to spray.
1 .
3,
Do not use any type of spray coating material
containing these solvents.
Do not use these solvents for equipment cleaning
or flushing.
If in doubt as to whether a material is compatible,
contact your material supplier.
AIR REQUIREMENTS
Minimum SCFM required @ 40 P.S.I. 3,4