Craftsman 315.212120 - Manual (Page 7)

PRODUCT SPECIFICATIONS
Blade Diameter 12 in. Cutting Capacity with Miter at O^/Bevel 0°:
Blade Arbor 5/8 in. max width x resulting height 7-7/8 in. x 2-1/2 in.
No Load Speed 4000 RPM Maximum Cutting Capacity with Miter at 45°/Bevel 0°:
Rating 120 Volts, 60 Hz-AC Only max width x resulting height 5-1/2 in. x 2-1/2 in.
Input 15 Amperes Maximum Cutting Capacity with Miter at 0°/Bevel 45®:
Net Weight 41 lbs. max width x resulting height 7-7/B in. x 1-3/4 in.
UNPACKING
Your Compound Miter Saw has been shipped
completely assembled except for the blade, miter lock
handle, and dust guide.
A WARNING; If any parts are missing, do not
operate №is ^1 until the missing parte are
replaced. Failure to do so could result in possible
serious personal injury.
' ■ Remove all loose parts from №e carton. Separate
arxf check with the list of loose parte. See Figure 2.
■ Remove the packing materials from around your
saw.
■ Carefully lift saw from the carton and place it on a
level work surface. This saw is heavy. To avoid
back injury, get help when needed.
■ Do not discard the packing materials until you
have carefully inspected the saw, identified all
loose parte, and satisfactorily operated your new
saw.
■ Your saw has been shipped with №e saw arm
locked in the down position. To release saw arm,
push down on top of saw arm and pull out the lock
pin.
See Figure 4.
■ Hand pressure should remain on the saw arm to
prevent sudden rise upon release of the lock pin.
■ Examine all parte to make sure no breakage or
damage has occurred during shipping.
If any parts are damaged or missing, do not attempt to
plug in the power cord and turn the switch on until the
damaged or missing parte are obtained and are
installed correctly.