Instructions for type a tractors, Instructions for type b tractors – Craftsman 486.24441 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTRUCTIONS FOR TRACTORS WITH DUAL
FRONT DECK SUSPENSION BRACKETS
STEP 4: (SEE FIGURE 4)
• Compare your tractor to the illustrations shown in
figure 4. If your tractor resembles the top illustration,
go to step 5. If your tractor resembles the bottom
illustration, go to step 7.
FIGURE 4
INSTRUCTIONS FOR TYPE A TRACTORS
STEPS: (SEE FIGURE 5)
• Remove any boits found in the holes indicated in the
illustration.
STEPS: (SEE FIGURE 6)
•
Attach the R.H. hanger bracket to the two front empty
holes on the right side of the tractor frame using two
new 3/8" X 1" hex bolts (D), 3/8" lock washers (L), and
3/8" flat washers (N) as shown. For the rear hole, use
a 3/8"
X
1" hex bolt (D), 3/8" lock washer (L) and 3/8"
flat washer (N) with a large 1/2" washer (M) placed
between the hanger bracket and the tractor frame.
Tighten. Repeat for the left side.
•
Skip to step 9.
INSTRUCTIONS FOR TYPE B TRACTORS
STEP?: (SEE FIGURE 7)
• Remove any bolts found in the holes indicated in the
illustration.