To remove mower (see fig. 19), To install mower (see fig. 19), Service and adjustments – Craftsman 917.259592 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
A
CAUTION; BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS;
® Depress clutch/brake pedal fully and set parking brake,
e Place motion control lever in neutral (N) position.
•
Place attachment clutch in “DISENGAGED^* position.
•
Turn ignition key "OFF” and remove key.
0
Make sure the blades and all moving parts have completely stopped.
« Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
___________________ _
TO REMOVE MOWER (See Fig. 19)
Mowerwil! beeasierto remove from the right side of tractor.
•
Place attachment clutch in “DISENGAGED" position
Move attachment lift lever forward to lower mowerto Its
lowest position.
Roll belt off engine pulley.
Disconnect clutch rod from clutch lever by removing
retainer spring.
^
Disconnect anti^sway bar from chassis bracket by
removing retainer spring
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
Disconnect front links from deck by removing retainer
springs,
Raise lift lever to raise suspension arms. Slide mower
out from under tractor,
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER DECK iS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS
TO INSTALL MOWER (See Fig. 19)
» Raise attachment lift lever to its highest position.
» Slide
mower
undertractorvtfith discharge guard to right
side of tractor.
•
Lower lift lever to its lowest position.
•
Install mower in reverse order of removal instructions.
CLUTCH LEVER
RETAINER
SPRING
ENGINE
PULLEY
FRONT
LINK
FIG. 19
21