Craftsman 973.111490 - Manual (Page 9)

OPERATION
KEYLESS CHUCK
See Figure 5.
Your new drill has a keyless chuck. As the name implies,
you can hand tighten or release drill bits in the chuck
jaws. Grasp and hold the collar of the chuck with one
hand. Rotate the chuck body with your other hand. The
arrows on the chuck indicate which direction to rotate
the chuck body in order to LOCK (tighten) or UNLOCK
(release) the drill bit.
UNLOCK
(RELEASE)
CHUCK
BODY
INSTALLING BITS
See Figure 7.
■ Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
■ Open or close chuck jaws to a point where the
opening is slightly larger than the bit size you
intend to use. Also, raise the front of your drill
slightly to keep the bit from falling out of the chuck
jaws.
■ Insert drill bit into chuck the full length of the jaws
as shown in figure 7.
CHUCK BODY
DRILL BIT
LOCK
(TIGHTEN)
CHUCK
COLLAR
A WARNING: Do not hold chuck body with one
hand and use power of the drill to tighten chuck
jaws on drill bits. Chuck body could slip in your
hand or your hand could slip and come in contact
with rotating drill bit. This could cause an
accident resulting in serious personal injury.
BIT STORAGE
See Figure 6.
When not in use, bits provided with your drill can be
placed in the storage area located on the top of your
drill as shown in figlire 6.
SCREWDRIVER
BITS
BIT
STORAGE
AREA
CHUCK COLLAR
RIGHT
Tighten the chuck jaws on drill bit.
To tighten the chuck jaws on drill bit; grasp and
hold the collar of the chuck with one hand, while
rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of
the arrow marked LOCK to tighten chuck jaws.
Do not use a wrench to tighten or loosen the
chuck jaws.
WARNING: Do not insert drill bit into chuck
* jaws and tighten as shown in figure 8. This could
cause drill bit to be thrown from drill resulting in
possible serious personal injury or damage to the
chuck.
Fig. 6 Fig. 8