Craftsman 917.248980 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MOUNTING COVER ASSEMBLY TO

SUPPORT ASSEMBLY (See Fig. 2)

NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting cover assembly
to tractor.

1. Position cover assembly on ground behind tractor.

2. Liftand rotate cover to align cover brackets with support

assembly tubes.

3. Slide cover assembly down onto the support tubes.

FIG. 2

CONTAINER ASSEMBLY (See Fig. 3)

1. Place bottom half inside of top half, as shown.

2. Place one foot inside bottom half and lift top half to

meet bottom half.

3. Press halves tightly together while lifting top to lock

into place as shown.

IMPORTANT:

BEFORELOCKINGTHETABS,

HOOKEDEDGES

ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS
SHOWN IN INSET.

4. Repeat for other containers.

CONTAINER
BOTTOM HALF

CONTAINER
TOP HALF

PRESS TOGETHER

TO FORM SEAL
WHILE LIFTING
TOP HALF

CONTAINER

BOTTOM
HALF

CONTAINER
TOP HALF

LOCKING
TAB

FiG.3

ASSEMBLY CHECK: Squeeze sides of lower half of con
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.