Assembly, Unpack carton & install handle, Handle height – Craftsman 917.292390 User Manual

Page 6: Tilling width, Tine operation, Install depth stake assembly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ASSEMBLY

UNPACK CARTON & INSTALL

HANDLE

^CAUTION: Be careful of exposed sta
ples when handling or disposing of carton
ing material.
IMPORTANT: When unpacking and as
sembling tiller, be careful not to stretch or
kink cable(s).
• Cut cable ties securing handle column.

• Slowly lift handle column up and slip

over handle mount.

• Remove packing from carton.
• Secure handle column to handle mount

using two (2) carriage bolts and two (2)
flange locknuts. Tighten both flange
locknuts securely.

• Remove packing material from handle

assembly.

• Insert plastic cable clip into hole in han-

die column.

• Route tine control cable through plastic

cable clip on handle column.

• Cut away carton.
• Cut cable ties securing illier to skid.
• Remove tiller from skid by pulling back

wards.

Engine Bracket Halves

Nut “A"

Depth Stake

Support

Stake
Spring

Depth

Stake

Support Bolt

"Hex Bolts, Lockwashers,

and Hex nuts

HANDLE HEIGHT

• Handle height may be adjusted to better

suit operator. (See “HANDLE HEIGHF

in the Service and Adjustments section
of this manual).

TILLING WIDTH
• Tilling width may be adjusted to better

handle your tilling conditions (See TINE
ARRANGEMENT" in the Service and
Adjustments section of this manual).

TINE OPERATION

• Check tine operation before first use.

(See TINE OPERATION CHECK” in the
Service and Adjustments section of this

manual).

INSTALL DEPTH STAKE ASSEMBLY

• Loosen nut “A”.
• Insert stake support between engine

bracket halves with stake spring down.:

• Bolt stake support to engine brackets '

with bolts, lock washers and nuts.
Tighten securely. Tighten nut “A”.

• Depth stake must move freely. If it does

not, loosen support bolt.