Craftsman 315.271350 - Manual (Page 10)

OPERATION
INSTALLING BITS
See Figure 8.
■ Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 2.
■ Open or close chuck jaws to a point where the
opening is slightly larger than the bit size you
intend to use. Also, raise the front of your drill
slightly to keep the bit from falling out of the chuck
jaws.
■ Insert drill bit into chuck the full length of the jaws
as shown in figure
8
.
■ Tighten the chuck jaws on drill bit.
CHUCK JAWS
CHUCK BODY
DRILL BIT
CHUCK COLLAR
RIGHT
Fig.
8
To tighten the chuck jaws on drill bit; grasp and
hold the collar of the chuck with one hand, while
rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of
the arrow marked LOCK to tighten chuck jaws.
Do not use a wrench to tighten or loosen the
chuck jaws.
WARNING; Do not insert drill bit into chuck
^ jaws and tighten as shown in figure 9. This could
cause drill bit to be thrown from drill resulting in
possible serious persona! injury or damage to the
chuck.
REMOVING BITS
See Figure 8.
■ Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 2.
■ Loosen the chuck jaws from drill bit.
■ To loosen: grasp and hold the collar of the chuck
with one hand, while rotating chuck body with your
other hand. Note: Rotate chuck body in the
direction of the arrow marked UNLOCK to loosen
chuck jaws.
■ Do not use a wrench to tighten or loosen the
chuck jaws.
■ Remove drill bit from chuck jaws.
ADJUSTABLE TORQUE CLUTCH
Your drill is equipped with an adjustable torque clutch
for driving different types of screws into different mate­
rials. The proper setting depends on the type of mate­
rial and the size of screw you are using.
TO ADJUST TORQUE
■ Identify the twenty four torque indicator settings
located on the front of your drill. See Figure 10.
■ Rotate adjusting ring to the desired setting.
For driving small screws.
For driving screws into soft
material.
For driving screws into soft and hard
materials.
For driving screws in hard wood.
For driving large screws.
For heavy drilling.
TO DECREASE
TORQUE
1
- 4
5
- 8
9-
1 2
13- 16
17-
2 0
2 1
- Ail
TO INCREASE
TORQUE
Fig. 9 Fig. 10
10