Craftsman 247.77011 - Manual (Page 5)

5
Figure 1
IMPORTANT: This unit is shipped without gasoline or
oil in the engine. After assembly, see OPERATION
section of this manual for proper fuel and engine oil
fill-up.
NOTE: Reference to right and left hand side of the
Yard Vacuum is observed from the operating
position. See Figure 1.
This Yard Vacuum has been completely assembled
at the factory, except for the handle, bag, and blower
chute. These parts are shipped loose in the carton.
A pair of safety glasses and a 20-oz. bottle of engine
oil are also included in the carton. See Figure 1.
REMOVING UNIT FROM CARTON
• Cut the corners of the carton.
• Remove all loose parts.
• Remove packing material.
• Lift unit from the rear to discard packing material
from under unit and roll unit out of carton.
• Check carton thoroughly for any other loose
parts.
LOOSE PARTS IN CARTON
(See Figure 1)
• Handle Assembly
• Bag
• Blower Chute
• Safety Glasses (Not Shown)
• A 20-oz. Bottle of Engine Oil
(may be located in bag)
• Operator’s Manual
DISCONNECTING SPARK PLUG
Before proceeding with assembly of your new Yard
Vacuum, disconnect the spark plug wire from the
spark plug and ground onto the retaining post on the
engine. This will prevent accidental starting of the
engine. See Figure 2.
Figure 2
ATTACHING THE HANDLE
• Unfold the upper handle until it aligns with lower
handle. Make sure the rope guide is on the right
side of upper handle. See Figure 1.
20-oz. Bottle
of Engine Oil
Blower
Chute
Upper
Handle
Rope
Guide
Wing
Nut
Wing
Nuts
Lower
Handle
Wing
Nuts
Carriage
Screw
Bag
Spark
Plug Wire
Retaining Post
ASSEMBLY