Setting up the tv automatically, For u.s. models only, To perform auto setup again – Sony KV-13M52 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
User Guide
Setting Up the TV Automatically
After you have finished connecting your TV, you will want to run AUTO
PROGRAM to set up your channels, (KV-13M42,13M52,13M53 see
page 17 for information on AUTO PROGRAM).
For models KV-20M42, 20S42, 20S43 only
POWER
1
Press (Q) to turn on the TV, the Auto Setup screen appears.
(U.S. models only)
(Canadian models only)
ENGLISH
[CH+]
ESPAÑOL
[CH-]
AUTO SET UP [VOL+]
DEMO
[VOL-]
MENU
[TVA/IDEO]
Rrst please connect
cable/antenna
Press (SET UP] to exit
ENGLISH:
[CH+]
ESPAÑOL:
[CH-]
FRANÇAIS:
[VOL+]
AUTO SET UP:[VOL-]
DEMO:
[TVA/IDEO]
First please
cable/antenna
connect
Press [SETUP] to exit
2
3
Make your language selection, the on-screen menus will change to
reflect your choice.
Follow the on-screen instructions to continue AUTO SET UP or for a
DEMO of the menus.
For U.S. models only
4
Press
to operate the on-screen menus without the remote
control. Follow the on-screen instructions to make adjustments to
your TV settings.
To perform Auto Setup again
□ Press the button on the front panel of the TV and follow steps 2-4.
To reset your TV to factory settings, turn the TV on. Then, while pressing the
button OD the remote control, press POWER onthe TV. The TV will turn
itself off, then back on, the original settings will be restored.
10