beautypg.com

Resetting the unit, Detaching the front panel, Resetting the unit detaching the front panel – Sony FM/AM CASSETTE CAR STEREO XR-C5100 User Manual

Page 4: Getting started, Attaching the front panel, Caution alarm

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Getting Started

Resetting the unit

Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the reset button with a pointed object,
such as a ball-point pen.

К

Reset button

Note

Pressing the reset button will erase all the tnenwrized

program and memory functions.

.

Detaching the front panel

The front panel of this unit can be detached to
prevent the unit from being stolen.

1

Press (OFF).

2

Press (RELEASE") to detach the front

panel then gently pull it out.

( RELEASE)

»

Be sure not to drop the panel when detaching it from the

unit.

* If you press (

RELEASE)

to detach the panel while the

unit is still turned on, the power uhli automatically turn

off to protect the speakers from being damaged.

Attaching the front panel

.•\ttach part ® of the front panel to part ® of
the unit as illustrated and push until it clicks.

Notes

• Make sure the front panel is right side up when attaching

it to the unit as it cannot be attached upside down.

• Do not press the front panel too hard when attaching it

to the unit. If can easihf be attached by pressing it lightly

against th‘’ unit.

• When yo . carry the front panel with you, keep it in the

supplied front panel case.

Do not press hard or put excessive pressure on the

display windows of the front panel.

Do not expose the front panel to direct sunlight, heat

sources such as hot air ducts or leave it in a humid place.

Never leave it on the dashboard etc. of a car parked in

direct sunlight where there may be a considerable rise in

temperature inside the car.

Caution alarm

If you turn the ignition key to the OFF position
without removing the front panel, the caution
alarm will beep for a few seconds (only when
the POWER SELECT switch is set to the ®
position). If you connect an optional power
amplifier to the LINE OUT and do not use the
built-in amplifier, the beep tone will be
disabled.

This manual is related to the following products: