Sony GDM-F400 - Manual (Page 6)

Setup
Before using your monitor, check that the following accessones
are included in your carton:
• Power cord (1)
• HD 15 video signal cable (1)
• USB cable (1)
• Macintosh adapter (1)
• Windows Monitor Information Disk (1)
• Warranty card (1)
• Notes on cleaning the screen's surface (1)
• This instruction manual (1)
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
■ Connecting to an IBM PC/AT or compatible
computer
■ Connecting to a Macintosh or compatible
computer
Use the supplied Macintosh adapter.
If your PC system Is not compatible with Plug & Play (DDC2AB
or 0DC2B+)
This monitor uses the No.9 pin in the video signal connector for Plug &
Play (DDC7AB or DDC2B+) compatibility. See page 5 for the location of
the No.9 pin.
• If your computer accepts the No.9 pin, use the supplied HD15 video
signal cable.
• If your computer does not accept the No.9 pin, please consult your
dealer for advice on obtaining an HD 15 adapter.
* Connect the supplied Macintosh adapter to the computer before •
connecting the cable. This adapter is compatible with Macintosh LC,
Performa, Quadra, Power Macintosh and Power Macintosh G3 series
computers. Macintosh II series and some older versions of PowerBook
models may need an adapter with micro switches (not supplied).
■ Connecting to the five BNC connectors
• Connect the cables from left to right in the following order Red-Green-
Blue-HD-'VD.
Notes
• Do not touch the pins of the video cable connector as this might bend
the pins.
• Plug & Play (DDC) does not apply to the five BNC cormectors. If you
want to use Plug & Play, cormect your computer to the HD 15 connector
using the supplied video signal cable.