Thermcraft XOV-21-21-19.5-1A-2-SL - Manual (Page 10)

MAINTENANCE
Note: Disconnect the power cord from the power source before performing
any service or maintenance on this unit.
7.1 Cleaning: Cleaning and decontamination are recommended on a regular
basis. To prepare the unit for cleaning, remove all interior parts if
assembled, such as shelves and shelf clips.
First clean the chamber with soap and water, rinse and let dry. To
decontaminate use a solution that is appropriate for your application. DO
NOT USE chlorine-based bleaches or abrasives as this can damage the
stainless steel components. DO NOT USE spray cleaners that might leak
through openings and cracks and get on electrical parts or that may contain
solvents that will harm the coatings.
WARNING: Never clean the unit with alcohol or flammable cleaners with
the unit connected to the electrical supply. Always disconnect the unit from
the electrical service when cleaning and assure all volatile or flammable
cleaners are evaporated and dry before reattaching the unit to the power
supply.
7.2 Use care when cleaning the door gasket to prevent damage which could
impair the positive door seal.
7.3 STORAGE: To prepare the unit for storage, remove all shelves and shelf
clips and disconnect the power supply. Be certain that the chamber is
completely dry and door is positively locked in the closed position. See
Section 3.3 Lifting/Handling, for proper transport procedures.
7.4 No maintenance is required on the electrical components. If the unit fails to
operate as specified, please see the Troubleshooting guide, Section 8.0,
before calling for service.
Section
7