Scilogex SK-D3309-Pro - Manual (Page 9)

Rocking Shaker & 3D Shaker
5
4.2 Display
Set
Err Display Faults
Set
Figure 3
Display Descriptions
Set Display when set target value.
Err Display in case of error happening.
Display area When Set display, this area shows
setting value; When Set disappears, this
area shows running value.
Table 3
5. Operation
• Place the instrument in safe and stable surface, ensure
the required operating voltage and power supply
voltage matched, and the socket must be earthed
reliably.
• Connect the power cable.
• Switch ON instrument.
• The instrument begins self-checking.
• When initialization is over, LCD displays the last
running values of speed.
• Rotate the speed control knob to set target speed.
a. Press the speed control knob to start shaking
function. Press the speed control knob again to stop
shaking function.
b. Rotate the timer control knob to set target time.
Press the timer control button to start shaking function
at the set speed and time. During operation, motion
can be stopped at any time by pressing the speed
control knob or timer control knob. If the timer control
knob is pressed again, the shaking function will start
again and the timer will restart countdown. When the
timer reaches zero, the unit will be automatically
halted and an alert will sound.
If these operations above are normal, the instrument is
ready to operate. If not, the instrument may be damaged
during transportation, please contact technical support of
manufacturer/supplier.
Note:
The speed value can be altered during shaking.