Mani connections – Schiit Mani User Manual
Page 2
1 Connect Mani’s RCA inputs to your turntable, using quality shielded cables.
2 Connect Mani’s RCA outputs to your preamp or headphone amp, using good RCA cables.
3 Connect the turntable ground to Mani’s ground input, if you have hum problems.
4 Connect the supplied 16VAC wall-wart to the Mani with the attached cord.
5 Turn on the power and enjoy your music!
VERY IMPORTANT: Turn on Mani FIRST, before any other components like power amps, or else you
may get some very loud pops through your system. Turn Mani off AFTER turning off power amps, for
the same reason. Also, DO NOT change gain switch settings with Mani on. Turn your whole system
off, change gain, and then observe the same turn-on sequence.
item
mani connections
18.200101
OUT
IN
GAIN 2
GAIN 1
LOAD
H L
47
47K
47
47K
H L
L
H
L
H
1
2
3
4
5
mani manual final.indd 2
9/18/14 8:34 PM