RearviewSafety RVS-770617N - Manual (Page 2)

Rear View Safety Inc. reserve the right to change or modify product specifications
or measurements without notice
.
Product Info
WARNING
n Make sure the monitor stand is
firmly fixed to secure location.
n
n
The monitor should be situated
away from direct sun light, heat,
water or moisture.
This product is made with precise
electronic components that should
be handled with care.
n
n
The rear view system is intented to be
used when the vehicle is in reverse.
Please do not watch movies or operate
the monitor while driving. It may result
in accident because of distraction.
Do not install the monitor where it may
obstruct drivers view or obstruct an air
bag device.
Do not attempt to service this product
on your own. If the system has any
problem, please disconnect power to
the unit and contact customer service.
Dropping the unit may cause possible
mechanical failure.
n
n
n Please take special care to the
wire positioning while installing the
rear view system in order to avoid
wiring damage.
Information
IN NO EVENT SHALL SELLER OR
MANUFACTURER BE LIABLE FOR
ANY DIRECT OR
CONSEQUENTIAL DAMAGES OF
ANY NATURE, OR LOSSES OR
EXPENSES RESULTING FROM
ANY DEFECTIVE PRODUCT OR
THE USE OF ANY PRODUCT.
SAFETY PRECAUTIONS
If you have any questions about
this product contact
, :
Troubleshooting
Monitor will not power up /
no backlight on power button
•
No image on screen
Check fuse
Check 12v+ to monitor.
•
•
•
•
•
•
Check ground connection.
Verify camera is on correct camera input.
Verify cable is connected to monitor.
Verify camera is connected to cable.
Connect known good camera and cable to monitor.
Product Info
Sensor
TV System
Effective Pixel
Electronic Shutter
Scanning System
Sync System
Resolution
Lens Angle
Sensor Area
Video Output
S/N Ratio
Water proof
Minimum Illumination
Operation Temperature
Storage Temperature
Other Items
Current Consumption
Power Supply
CMD
PAL
628X586 pixels
1/50-1/100,000 sec
2:1 Interlace
Internal
420 TV Lines
2.8mm/120 - 1.8mm/710
5.961mm X 4.276mm
1.0Vp-p 75 Ohm
More than 48db
Ip67
0.2Lux/F1.5(0 Lux With LED)
-30 C~60 C (Rh95% MAX)
Automatic white balance,
Agc and BLC
DC 12V+10%
-20 C~60 C (Rh95% MAX)
NTSC
656X462 pixels
1/60-1/100,000 sec
o
No More 300mA
This system is complete with a color 3.5" LCD monitor 120° CMD
camera with night vision and all the wires, connectors and mounts
you will need. The system is weather proof, strong and reliable, shock
resistant and comes with a full year warranty.
3.5 LCD color monitor
120 angle CMD camera with night vision
15' RCA extension cable for camera
Power Cables
Drill Bit
Product Includes:
Monitor Dimensions 3.3/4"(W) x 3"(H) x 3/4" (D)
Camera Dimensions 1" Diameter