Crate Amplifiers VTX212 - Manual (Page 6)

6
MADE IN CHINA
FOR SLM ELECTRONICS
1400 FERGUSON AVE.
ST. LOUIS, MO 63133
PATENT #5,032,796
CAUTION
WARNING:
AVIS: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK DO NOT OPEN
#3031613
EXTENSION
SPEAKER
INSERT FOOTSWITCH
DSP
BANK A
BANK B
CHANNEL
CLEAN
SOLO/RHYTHM
FUSE
100VAC: T2.5A 250V
120VAC: T3A 250V
230V/240VAC: T1.6A 250V
27 28 29 30 31
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation.
The Bottom Panel:
27: FUSE: The fuse protects the amplifier from damages caused by a faulty AC power source and/or other prob-
lems. If the fuse opens, replace it ONLY with the same size and type. If fuses continue to fail, check the AC source
– if the source is okay, contact your Crate dealer for service information.
28: EXTENSION SPEAKER: Use this jack to connect the amplifier to an external speaker cabinet. This jack is
wired in series with the internal speaker(s) which remain active when an extension speaker is connected.
29: DSP A/B FOOTSWITCH: Use this jack to connect one of the footswitch cables to the three-button footswitch
(supplied). This allows you to select between two presets for each of the three channels. Additional information
about the operation of the footswitch is on page 9.
30: CLEAN/SOLO/RHYTHM FOOTSWITCH: Use this jack to connect one of the footswitch cables to the three-
button footswitch (supplied). This allows you to remotely switch between the Clean and Distortion channels and
between the Solo and Rhythm channels. (See page 9.)
31: INSERT: Use this jack to connect an external signal processor to the amplifier. Use Crate’s STP201, STP202,
or STP203 stereo-to-mono Y-cord or an adapter such as Crate’s YPP117 and two 1/4” mono signal cables to con-
nect to the effect as shown below.
32: AC LINE CORD (not shown): This grounded power cord is to be plugged into a grounded power outlet, wired
to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the bot-
tom panel. Do not attempt to defeat the safety ground connection.
TIP
RING
SLEEVE RETURN
SEND
GROUND
Stereo-to-mono Y-cord:
to Insert
jack
to Insert
jack
(STP201, 3'
STP202, 6'
STP203, 9')
(YPP117)
(1/4"-TO-1/4"
MONO SHIELDED
CABLES)
to
effect
"OUT"
jack
to
effect
"IN"
jack
External Effect
TIP
RING
SLEEVE
Y-adapter and 2 cables:
External Effect
RING
RING TIP
TIP
to
effect
"OUT"
jack
to
effect
"IN"
jack
VTX212
Three-Channel Guitar Amplifier with Advanced DSP