Pro-Ject Audio Systems Pro-Ject 2Xperience Basic+ ACRYL - Manual (Page 5)

© Audio Trade GmbH · Pro-Ject 2 X perience Basic +/ Ortofon MC 25 E · Revision 2011.10.15/2011.10.15
5
Maintenance and cleaning
Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic
cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic
cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber
parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage.
If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching.
!
Always disconnect the record player from the mains power supply as a precaution before maintenance!
Fitting and connecting the cartridge
** All cartridges with half inch mounting holes can be fitted. Leaving the needle's protection cover on, fit the
cartridge to the headshell (12) using the screws supplied with the cartridge by passing one screw through
each slot in the headshell (12). Do not tighten the nuts yet.
Connect the tonearm wires to the cartridge pins as follows:
white
left channel positive (L+)
red right channel pos. (R+)
green right channel return (R -)
blue left channel return (L -)
The full sound quality of the record player can only be achieved if the cartridge is correctly adjusted. Particular
tools like the Pro-Ject alignment tool “Align it” are required to accomplish this job properly.
If you are not well acquainted with the adjustment of cartridges you are advised to call upon the willing help of
your Pro-Ject dealer to accomplish this task for you.
Please note: adjusting a cartridge and tonearm calls for the greatest care in order to avoid damaging
the cartridge or tonearm bearings. Leave this work to your dealer if you are in any way unsure of the
necessary steps and precautions to be taken.
Useful tips
The record player should be positioned on a low-resonance surface such as wood or multiple layer ply board
to avoid structural vibrations disturbing replay.
Technical specifications Pro-Ject 2 X perience Basic + / Pro-Ject 8.6 UniPivot
Nominal speeds 33/45 r.p.m.
Speed variance ±0,9%
Wow and flutter ±0,15%
Signal to noise -65dB
Downforce range 15-30mN
Effective tonearm length 8,6" (218,5mm)
Overhang 18,5mm
Power consumption
2W
Outboard power supply 16V/500mA AC, suitable for your country's mains supply
Dimensions (W x H x D) 465 x 130 x 340mm
Weight 6,4kg
Length Connect it Phonokabel
approx. 123cm
Capacity Connect it connection cable 65pF/meter
Technical specifications Low-Output MC-Cartridge Ortofon MC 25 E
Frequency range 20-30.000Hz
Channel separation 22dB/1kHz
Output voltage 0,5mV
Recommended load resistance 100ohms/amplifier connection – MC-input
Compliance/stylus type 16μm/mN – elliptical, nude
Recommended tracking force 20mN
Weight 10,5g