Pro-Ject Audio Systems Tuner Box User Manual

Page 2

Dear music lover,

thank you for purchasing a PRO-JECT AUDIO FM-tuner.

In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Connectors

FM Ant.

75 Ohm

Unbal.

Make all connections whilst the tuner is disconnected from the power supply.

Take care to connect the left and right channels correctly. The right channel is usually marked red,
the left channel black or white.

Connection to an amplifier

When the Tuner Box is used with a Pro-Ject amplifier connect the line level output to input 1(In 1) on the amp.
When used with another manufacturers amplifier connect the line level output to the input marked Tuner on
the amp.

Antenna input

Connects any antenna cable with a co-axial DIN-plug / US-model F-plug.

Remote switch-on

The pre amplifier Pro-Ject Pre Box provides a trigger signal to switch on and off the Tuner Box remotely and

for operating the input expander Pro-Ject Switch Box.
The switching lead should be connected to the Trigger Switch socket on Pre Box and the Trigger In socket
on the Tuner Box. In order to ensure correct remote switching, the Tuner Box must be connected to the line
level input socket (In 1) on the Pro-Ject Pre Box.
The trigger signal is passed through the Trigger In socket to the Trigger Out socket of the Tuner Box,
through which it can be relayed to the input expander Pro-Ject Switch Box.
Two approx. 45cm long trigger leads are supplied with the Pro-Ject Tuner Box. Longer leads may be
purchased from your Pro-Ject dealer.
Do not use this trigger output for any other connections for which it is not designed.

If any other input is used to connect the Pro-Ject Tuner Box to a Pro-Ject Pre Box, the trigger lead
should not be used.
Switch off all units and disconnect them from the mains before connecting or disconnecting the
trigger lead. Failing to do so could result in damage to the units.

Mains power connection

The unit is supplied with a power supply suitable for your country's mains supply. Check the label before
connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from the
power supply to the Power ~16V socket before connecting the power supply to the mains.