beautypg.com

Pro-Ject Audio Systems Phono Box II User Manual

Page 3

background image

© Audio Trade GmbH · Pro-Ject Phono Box II · Revision 15.10.10/15.12.10

3

Technical specifications Pro-Ject Phono Box II

Input impedance, MM / MC:

47kohms/120pF / 100ohms/120pF

Gain, MM / MC:

40dB / 60dB

Output voltage typically, MM / MC:

300mV at 1kHz - 3mV (MM Input) / 0,3mV (MC input)

Max. output:

9,5V (1kHz)

Noise floor, MM / MC:

86dB (94dB - A weighted) / 68dB (75dB - A weighted)

THD, MM / MC:

0,01 / 0,05%

RIAA-equalisation curve accuracy:

20Hz - 20kHz / max. 0,5dB

Input:

1 pair RCA/Phono sockets

Line-level output:

1 pair RCA/Phono sockets

Outboard power supply:

16V/200mA AC, suitable for your country's mains supply

Power consumption:

16V/30mA AC

Dimensions W x H x D (D with sockets): 103 x 36 x 103 (115)mm
Weight:

570g without power supply

Potential incorrect use and fault conditions

No signal on one or both channels:

No connection between player and phono amplifier ore amplifier. This could be due to a faulty plug,

broken wire or solder joint or simply loose plug/socket connection.

Strong hum:

No earth connection from cartridge or arm or arm cable to phono amplifier, or earth loop.

Output too quiet or too loud, or distorted:

MM / MC mode incorrectly set - input overloading or insufficiently amplified.

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.



PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright © 2005. All rights reserved.

The information was correct at the time of going to

press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.