Pro-Ject Audio Systems Speed Box S User Manual

Page 2

Dear music lover,
thank you for purchasing a PRO-JECT AUDIO Speed Box. * The unit permits electronic speed change of your
Pro-Ject record player between 33 and 45 r.p.m. and also permits the replay of shellac records by allowing
** 78 r.p.m. with an appropriate pulley and cartridge.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Safety instructions

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply.
The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily
accessible at all times.

Never handle the device, the power supply while your hands are wet or damp.

Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,

such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.
Never place any naked flame sources, such as lighted candles on or near the device. The product shall not

be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Connecting the record player

Pro-Ject Audio Systems,

Vienna, Austria

18V

Output

~ 16 V

Connect the power cable supplied *** (polarity

) to the socket Output ~16V and to the power supply

socket of the record player. The original power supply of the record player is then no longer required.

Make all connections whilst the Speed Box is disconnected from the power supply.

Models with 16V/AC wall power supply only. 16V/190mA AC max..
* All Juke Box, Elemental and Debut Carbon models, all Phono and Phono/USB models, all models
with Automatic switch-off (like Debut III E) and electronic speed change (like Debut Carbon Esprit SB,

RPM 6.1 SB,

pression III Comfort,

perience Comfort),

tension (all models) and Signature may not

be used with the Speed Box.

Mains power connection

Connect the low voltage plug from the power supply to the socket Power 18V

before connecting the power

supply to the mains.

Never use any other power supply than the one supplied with the unit.