Pro-Ject Audio Systems CD Box DS User Manual
Page 5

© Audio Trade GmbH · Pro-Ject CD Box DS · Revision 2013.1.15
5
Replacing batteries
Proceed as follows:
Unlock and slide open the battery case cover
Replace the battery.
Make sure the battery is the right way round !
Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
Technical specifications Pro-Ject CD Box DS
Supports:
CD, CD-R, CD-RW and Hybrid-SACD
Frequency response:
20Hz - 20kHz/±0,15dB
Noise floor:
>103dBA
THD: <0,01%
Line-level output:
1 pair RCA/phono sockets
Output voltage:
max. 2Vrms
Digital output:
1 x co-axial (S/PDIF)
D/A-converter:
Burr Brown PCM 1796. 24Bit/192kHz, 8-times oversampling
Outboard power supply:
18V/1.000mA DC, suitable for your country's mains supply
Power consumption:
330 - 600mA DC, <1W in standby
Replacement battery remote control:
1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): 206 x 72 x 194 (200)mm
Weight:
2.670g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright
©
2012. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.