Pro-Ject Audio Systems Switch Box User Manual

Page 3

Selecting an input together with a Pro-Ject Pre Box

Pressing the Input Select button selects the In 1 to In 5 inputs in turn. Select the inputs using the remote
control buttons marked CH- or CH+.
If Input 1 is selected, the LED over the Input Select button lights up green. If the inputs 2 to 5 are selected, it
lights up red. The selected input will be shown by the corresponding LED on the Switch Box .

Pre Box

Power

Volume

Input

Select

Selecting an input together with a Pro-Ject Receiver Box, Stereo Box and a Pre Box SE
Selecting an input when used with an amplifier from another manufacturer

Pressing the grey button on the front of the Switch Box selects the In 2 to In 5 inputs in turn. The selected input
(2 to 5) will be shown by the corresponding LED on the Switch Box.

The dark grey button on the front of the Switch Box is without function when the Switch Box is

connected to a Pro-Ject amplifier via the supplied connecting cable.

Technical specifications Pro-Ject Switch Box

Gain: 0dB
Line-level inputs:

1 pair RCA/Phono sockets,

3 x 3-pole 3,5mm co-axial jack

Line-level outputs:

1 pair RCA/Phono sockets,

Trigger:

2-pole 2,5mm co-axial jack

Outboard power supply:

16V/200mA AC, suitable for your country's mains supply

Power consumption:

16V/30mA AC

Dimensions W x H x D (D with sockets): 103 x 36 x 103 (109)mm
Weight: 630g

without

power

supply

Service

Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing

process of technical development.