Pro-Ject Audio Systems Stereo Box User Manual

Page 4

Replacing batteries

Proceed as follows:

• Slide open the battery case cover
• Replace the battery.

Make sure the battery is the right way round

• Close the battery case cover

Battery type: 1 x CR 2032 / 3V

Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.

Technical specifications Pro-Ject Stereo Box

Power output:

2 x 20W/30W at 8ohms/4ohms (both channels driven)

Frequency response:

20Hz - 20kHz (±0,2dB)

Channel separation:

> 40dB at 20kHz

Noise floor:

> -100dB (A weighted)

THD:

< 0,05% at 10W

Gain: 22dB
Line-level inputs:

2 pairs RCA/Phono sockets

Input impedance:

20kohms

Trigger Switch:

2-pole 2,5mm co-axial jack

Speaker connectors:

4mm ∅ banana plugs, spades connectors or naked wire

Outboard power supply:

20V/3A DC (peak 7A DC), suitable for your country's mains supply

Power consumption:

20V/3A DC

Replacement battery remote control:

1 x CR 2032 / 3V

Dimensions W x H x D (D with sockets): 103 x 36 x 103 (122)mm
Weight:

720g without power supply

Service

Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for

further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.