Pro-Ject Audio Systems Amp Box S Mono User Manual

Page 2

Dear music lover,
thank you for purchasing a PRO-JECT AUDIO amplifier.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Safety instructions

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply. The power cord is
used to disconnect the unit from the mains. Make sure that the power cord is easily accessible at all

times.

Never handle the device, the power cord/power supply while your hands are wet or damp.

Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.

Never place any naked flame sources, such as lighted candles on or near the device. The product shall not
be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Connectors

Trigger

Out

Trigger

24V

Make all connections whilst the amplifier is disconnected from the power supply.
Only connect one loudspeaker with an impedance not less than 4 ohms.
Red terminal carry the positive signal (+), black connections the negative signal (–). Make sure the

polarity of the connection is correct at each end of the cables.
Never use any other power supply than the one supplied with the unit.

Connection to the preamplifier

The socket marked Input is for connecting the cables from your pre-amp or AV processor. The preamplifier

signal can be relayed to further units via the by pass output socket.

Connection to the speaker

The output terminal accept loudspeaker cables terminated with 4mm  Banana plugs, spades connectors or
naked wire.

Mains power connection

Connect the low voltage plug from the power supply to the Power

24V socket of the amplifier before

connecting the power supply to the mains.