Desa Tech SL30NT - Manual (Page 9)

9 104463
OWNER’S MANUAL
INSTALLATION
Continued
Continued
Figure 9 - Attaching Stove Legs
Bottom Of
Stove Unit
Leg
Bolt
Figure 10 - Attaching Stove Bottom
Bottom Of
Stove Unit
Bolt
Washers
Stove
Bottom
9. Fasten stove bottom to stove with four
(4) M6 x 1 - 25mm bolts. Use a flat
washer and lock washer with each bolt.
Tighten bolts into threaded holes on
stove body (see Figure 8, page 8 and
10). Use an adjustable wrench or a
10mm socket.
Figure 11 - Attaching Stove Door (Appearance May Vary Depending on Model)
Step
Bolt
Door
Hinge
Threaded
Hole
Stove
Door
Stove Bottom Bolt
Shoulder
Door
Hinge
Step
Bolt
Bolt
Shoulder
Adjusting Nut
Bolt Stop
Catch Bolt
Door Claw Door
Figure 12 - Catch Bolt and Door Claw Orientation
Stove
Door
10. Attach stove door by inserting step bolt
through door hinge pivot holes and into
threaded hole in stove body (see Fig-
ure 11). Use an adjustable wrench or a
12mm socket to fasten step bolt.
Tighten step bolt until snug. Make sure
door moves freely.
11. Install door catch bolt (M8 x 1.25-
55mm with two M8 hex nuts) into
threaded hole on stove body (see Fig-
ure 8, page 8). Use an adjustable
wrench or a 12mm socket. The catch
bolt has two hex nuts attached to it (see
Figure 12). The top nut is a bolt stop
and the bottom nut is for door leveling
adjustment.
12. Check general catch bolt alignment
with door claw. Make final adjustment
and door leveling after stove is in nor-
mal standing position.
13. Carefully lift stove back up on its four
attached legs.
14. If available, install gas log heater in-
side stove cavity before installing the
back panel (see Installing Gas Log
Heater Into Stove, page 10).
15. Fasten back panel to stove with six (6)
M6 x 1 - 20mm bolts and washers.
Make sure product identification label
is located on the outside in lower left-
hand corner.