Dell S2415H Monitor - Manual (Page 21)

Setting Up the Monitor | 21
Setting Up the Monitor
Attaching the Stand
NOTE: The stand riser and stand base are detached when the monitor is shipped
from the factory.
NOTE: The procedure below is applicable for the default stand. If you purchased
any other stand, see the documentation shipped with the stand to set it up.
WARNING: Place monitor of a flat, clean, and soft surface to avoid scratching the
display panel.
1 Assemble the stand riser to stand base.
a Attach the stand riser to the stand base.
b Tighten the thumbscrew below the stand base.
2 Attach the stand assembly to the monitor.
a Remove the cover and place the monitor on it.
b Insert the two tabs on the upper part of the stand in the slots on the back of the
monitor.
c Press the stand down till it snaps into place.