Dell ST2220 Monitor - Manual (Page 24)

b. Align the stand assembly bracket to the monitor groove.
c. Insert the bracket towards monitor until it locked in place.
Connecting the Monitor
To connect your monitor to the computer perform the following steps/instructions:
1. Turn off your computer and disconnect the power cable.
2. Connect the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not use all the cables on the
same computer. Use all of the cables only when they are connected to different computers with appropriate video systems.
Connecting the blue VGA cable
After you have completed connecting the VGA cable, follow the procedure below to complete your monitor setup:
1. Plug the power cables for your computer and monitor into a nearby outlet.
2. Turn on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not display an image, see
Solving Problems .
Attaching the Soundbar (Optional)
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions .
NOTE: The Graphics are used for the purpose of illustration only. Appearance of the the computer may vary.