Setting up the monitor, Attaching the stand, Connecting your monitor – Dell U2311H Monitor User Manual
Page 30
Back to Contents Page
Setting Up the Monitor
Dell™ U2211H / U2311H Monitor User's Guide
Attaching the Soundbar (optional)
Attaching the Stand
To attach the monitor stand:
1.
Remove the cover and place the monitor on it.
2.
Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
3.
Press the stand till it snaps into its place.
Connecting Your Monitor
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
NOTE:
The stand is detached when the monitor is shipped from the factory.
NOTE:
This is applicable for a monitor with a stand. When other stand is bought, please refer to the respective stand setup guide for set up
instructions.
WARNING:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.
Connect the blue (VGA) cable from your monitor to your computer.
NOTE:
If your computer supports a white DVI connector, unscrew and detach the blue (VGA) cable from the monitor and then
connect the White DVI cable to the monitor and the white DVI connector on your computer.