Setting up the monitor, Attaching the stand, Connecting your monitor – Dell E2211H Monitor User Manual
Page 27
Back to Contents Page
Setting Up the Monitor
Dell™ E2211H/E2311H monitor User's Guide
Attaching the Soundbar (Optional)
Attaching the Stand
To attach the monitor stand:
1.
Remove the cover and place the monitor on it.
2.
Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
3.
Press the stand till it snaps into its place.
Connecting Your Monitor
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
2.
Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not connect both cables on the same computer. Use both the
cables only when they are connected to two different computers with
appropriate video systems.
Connecting the White DVI Cable
Connecting the Blue VGA Cable
NOTE:
The stand is detached from monitor when it is shipped from the factory.
NOTE:
This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for set up
instructions.
WARNING:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.