Setting up the monitor, Attaching the stand, Connecting your monitor – Dell P1911 Monitor User Manual
Page 31: Connecting the white dvi cable
Back to Contents Page
Setting Up the Monitor
Dell™ P1911
Flat Panel Monitor User's Guide
Attaching the Soundbar (optional)
Attaching the Stand
To attach the monitor stand:
1.
Place the stand on a flat surface
2.
Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.
3.
Lower the monitor so that the monitor mounting area snaps ontoorlocks on to the stand.
Connecting Your Monitor
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
2.
Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not use both cables on the same computer. Use both the
cables only when they are connected to two different computers with
appropriate video systems.
Connecting the white DVI cable
NOTE:
The stand is detached when the monitor is shipped from the factory.
NOTE:
This is applicable for a monitor with a stand. When the OptiPlex™ USFF 780/ OptiPlex™ SFF 980
AIO stand is bought, please refer to the respective AIO
guide for set up instructions.
WARNING:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.