Removing the monitor stand – Dell P1913 Monitor User Manual

Page 26

CAUTION:

Do not use with any device other than the Dell Soundbar.

NOTE:

The Soundbar power connector (+12 V DC output) is for the optional Dell Soundbar only.

To attach the Soundbar:

At the back of the monitor, attach the Soundbar by aligning the two slots with the two tabs along the bottom of the monitor.

Slide the Soundbar to the left until it snaps into place.

3. Connect the Soundbar with the DC power connector.

Insert the mini stereo plug from the back of the Soundbar into the computer's audio output port.

For HDMI/DP, you can insert the mini stereo plug into the monitor’s audio output port. If there is no sound, check your PC if the Audio output is configured to

HMDI/DP output.

Removing the Monitor Stand

NOTE:

To prevent scratches on the LCD screen while removing the stand, ensure that the monitor is placed on a soft, clean surface.

NOTE:

This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for the set-up instructions.

To remove the stand:

1. Place the monitor on a flat surface.