Crosley Radio Crosley iJuke CR17 - Manual (Page 3)

External Outputs Auxiliary Inputs
9
Specification
Power Source : Input AC110-240V 50-60Hz
Output DC14V 2.5A
Power Consumption : 30W
Speaker
: Dynamic type 4” 4 Ohm x 2
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
Connecting Optional Equipment WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL. The iJuke (CR17) is equipped with external speaker
outputs which will allow you to hook up external
speakers.
1
The speaker jacks for external speakers are 4
ohm jacks and are located on the back of the
unit. Beside the speaker jacks is the external /
internal speaker switch which is labeled (EXT.
/ INT.) When using external speakers, this switch
must be switched to the EXT. position. Doing
this turns off the internal speakers in the unit
and redirects to power to the external speakers.
2
If you decide not to use the external speakers,
be sure the switch is on INT. position or the
internal speakers will not work.
You can connect external audio devices such as CD
Players or other MP3 players by using the Auxiliary
Input (Aux In) jack and the supplied Auxiliary cable.
To connect an external devise, follow the directions
below.
1
Connect one end of the supplied Auxiliary Cable
to the Aux In jack on the back of your unit.
2
Connect the other end of the cable to the Audio
Out Jack or Headphone Jack of your external
component.
Note: If your external component doesn’t have a 3.5mm
output jack or headphone jack, you will need a
different cable to make the connection. Check
your local electronics retailer for different cable
options.
3
Begin play on the external component and adjust
the volume of the iJuke to your desired listening
level.
4
See the owner’s manual for your external
component for information on its operations.
Auxiliary cable
The exclamation point
within an equilateral
triangle is intended to
alert user to the
presence of important
operating and
maintenance (servicing)
instruction in the
literature accompanying
the appliance.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
The lighting flash with
arrowhead symbol, within
an equilateral triangle, is
intended to alert user to
the presence of uninsulated
"dangerous voltage" within
the product's enclosure
that may be of sufficient
magnitude to constitute
risk of electric shock
to persons.
CAUTION: TO REDUCE
THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE
COVER (OR BACK). NO
USER - SERVICEABLE
PARTS INSIDE. REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL.