Clarion DXZ925 - Manual (Page 25)

280-7752-00
DXZ925
29
English
Digital Radio / DAB Operations
1. Perform the following operation depending
on the connected model.
Press and hold the [TITLE] button for 1 second or
longer.
2. Press the [ a] or [d] button to select “INFO
SEL”, then press the [ ] button to enter
“INFO SEL” mode.
3. Press the [ a] or [d] button to select an in-
formation item. You can select any of 6 items:
4. Perform the following operation depending
on the connected model.
Turn the [ROTARY] knob clockwise or
counterclock wise to set the information item
for ON or OFF.
5. Press the [TITLE] button to return to the pre-
vious display.
Switching the PTY display language
You can select one of 2 languages (English or
French) for the PTY displayed in the display.
∗ The factory default setting is “ENGLISH”.
1. Press and hold the [TITLE] button for 1 sec-
ond or longer to switch to the adjustment se-
lection display.
2. Press the [ a] or [d] button and select
“LANGUAGE”.
3. Turn the [ROTARY] knob clockwise or coun-
terclockwise to select the desired language.
4. Press the [TITLE] button to return to the pre-
vious mode.
TA (Traffic Announcement)
In the TA standby mode, when a traffic announce-
ment broadcast starts, the traffic announcement
broadcast is received as top priority regardless of
the function mode. Traffic programme (TP) auto-
matic tuning is also possible.
∗ This function can only be used when “TP” is lit in
the display. When “TP” is lit, this means that the
DAB broadcast station being received has traffic
announcement programmes.
INFORMATION item
ENGLISH Contents
TRAVEL Transport flash
WARNING Warning / Service
NEWS News flash
WEATHER Area weather flash
EVENT Event announcement
SPECIAL Special event
● Setting TA standby mode
If you press the [ISR] button when only “TP” is lit
in the display, “TP” and “TA” light in the display
and the unit is set into TA standby mode until a
traffic announcement is broadcast. When a traf-
fic announcement broadcast starts, “TRA INFO”
appears in the display. If you press the [ISR] but-
ton while a traffic announcement broadcast is
being received, the traffic announcement broad-
cast reception is cancelled and the unit goes
into TA standby mode.
● Cancelling TA standby mode
With “TP” and “TA” lit in the display, press the
[ISR] button. The “TA” in the display goes off and
TA standby mode is cancelled.
∗ If “TP” is not lit, pressing [ISR] button searches for
a TP station.
● Searching for a TP station
When “TP” is not lit, if you press the [ISR] but-
ton, “TA” in the display lights and the unit auto-
matically receives a TP station.
Note:
• If a TP station is not received, the unit continues
the search operation. Pressing the [ISR] button
again goes off “TA” in the display and stops TP
station searching.
Auto store function for TP stations
You can automatically store up to 6 TP stations
into preset memory. If the number of TP that can
be received is less than 6, broadcast stations al-
ready stored in memory are left without being
overwritten.
With “TA” lit in the display, press and hold the
[SC] button for 2 seconds or longer. The TP sta-
tions with the good reception sensitivity are
stored into preset memory.
∗ Even if you select FM1 or FM2, a TP station is stored
into memory for FM3.
280-7752-00_Eng 12/12/01, 6:38 PM 29