Craftsman SPIKER 486.24331 - Manual (Page 9)

9
FIGURE 11
• Push two flange bearings into each of the drive disk
assemblies. See figure 11.
• Push a flange bearing into each of the seven drive
disks, from the side shown in figure 12.
FIGURE 12
• Press flanged bearings into both of the end plates.
See figure 13.
• Place the 1/4" thick spacer onto the spike disk
shaft and then insert the shaft through the flanged
bearing in the left hand end plate. See figure 13.
FIGURE 13
SPIKE DISK
LONG SPACER TUBE
• Place a short spacer tube, a drive disk, a 5/8" flat
washer, another drive disk and a second 5/8" flat
washer onto the shaft. Fit the short spacer tube onto
the flanged bearing in the end plate. See figure 14.
FIGURE 14
FIGURE 15
IMPORTANT: When assembling the spike disks, be sure
they face in the direction shown in the instructions.
• Place two spike disks, separated by a long spacer
tube, onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure
15.
DRIVE DISKS
5/8" FLAT WASHER
SHORT SPACER
TUBE
FLANGED
BEARING
FLANGED
BEARING
DRIVE DISK
ASSEMBLY
FLANGED
BEARING
SPIKE DISK
FLANGED
BEARING
FLANGED
BEARING
1/4" THICK SPACER
SPIKE DISK SHAFT