Cisco Cisco Multiband Wall-Mount Antenna AIR-ANTM5560P-R - Manual (Page 10)

10
Cisco Multiband Wall-Mount Antenna (AIR-ANTM5560P-R)
OL-6847-01
Installation Instructions
Installation Instructions
The following sections contain procedures for installing the antenna on a wall or pole. The following
parts are included with your antenna:
• Molded antenna mount
• Molded wall mount
• Articulating arm
• Four 8-32 nylon lock nuts
• Two 1/4-in. lock washers
• Two 1/4-in. flat washers
• Two 1/4-20 x 1-1/4-in. machine screws
• Two 1/4-20 hex nuts
For mounting on a wall:
• Four wall anchors
• Four 8-18 x 3/4-in. self-tapping Phillips screws
For mounting on a pole:
• Two worm tie clamps
Tools and Equipment Required
To install the antenna, you will need the following tools and equipment:
• Adjustable wrench
• A Phillips screwdriver
• A pencil
For mounting on a wall:
• A portable hand or electric drill
• A 3/16 in. (4.7 mm) drill bit
For mounting on a pole:
• A small flat-blade screwdriver
Mounting on a Wall
This section provides instructions for mounting the antenna on a wall. (See Figure 6 .)