Crane EE-5063 - Manual (Page 7)

ASSEMBLY
1. Lift the water tank off the central body.
2. Turn over the water tank and unscrew the water tank cap
at the bottom of the tank by turning it counterclockwise.
(See Fig. 6)
Fig. 6
3. Fill water tank with cold water; do not fill all the way to
the rim.
(See Fig. 7)
Note: To avoid possible white dust due to hard water it
is recommended to use distilled water.
DO NOT
use hot water. Use cool tap water.
DO NOT
add any medication to other additives to the
water
DO NOT pour water into Vapor Outlet Channel (part 7,
Fig.2 on page 4)
Fig. 7
4. Replace the water tank cap, aligning the threads on the
tank with the threads on the cap, and turn it clockwise.
(See Fig. 8)
Fig. 8
5. Turn the tank over, holding it by the top handle, and
place it on the central body, making sure it fits perfectly.
Place the water tank cap with output slots on top of the
water tank. (see Fig. 9)
Fig. 9
6. Plug the power cord into a wall socket (do not use extension cord) and turn on the
unit. The On/Off switch is located at the turning knob (see figure 1).
7. The Power Light will turn on red. In a few seconds it will switch to green, indicating
that enough water is in the water basin, and vapor will start emitting through the
openings at water tank lid.
6